Vinyl Wall Art Tutorial

Step One

Completely clean and dry wall area where vinyl image is to be placed. For best results do not use a a cleaner that will leave behind residue.  This is how your vinyl wall art will come shipped to you.

Note:: Please make sure you smooth over the transfer paper a few times to ensure that the vinyl wall art is still stuck to it good. I smooth over it many times before shipment, but its better for you to run over it a few times as well.

Step Two

Peel backing off vinyl slowly.

Step Three

Lightly place image on wall using a level to ensure correct placement.  Once image is in place, user applicator stick to burnish* vinyl onto wall. For best results overlapping strockes when burnishing.

*Burnishing is a rubbing or polishing action that used an applicator stick or squeegee to spread or apply the vinyl to the wall.

Step Four

Gently peel back transfer tape at a 45 degree angle. If vinyl starts to come off with transfer tape, lay area back down and burnish* again.

*Burnishing is a rubbing or polishing action that used an applicator stick or squeegee to spread or apply the vinyl to the wall.

Step Five

After peeling away transfer paper check for any air bubbles that you may have between the wall and vinyl. If you don't have any then you are a very good at this..but if you do have a few bubbles.. don't worry. Just use the burnishing* method and try and smooth out any air bubbles you may have.

*Burnishing is a rubbing or polishing action that used an applicator stick or squeegee to spread or apply the vinyl to the wall.

Final Product

There you have it. You just applied your first vinyl wall art. Use this same method for walls, windows, cars, wood, etc.

If you have any questions or you find a method that works better please email me or leave a comment on this post.  Thanks for looking!